Sprayer troubleshooting

Ordinary sprayer: (1) The handle does not work. When the stem pressure is compressed, if the pump is running water or not working, the cup is often shrinking, hardening or damaged, so you should remove the oil or replace the new one. (2) Poor atomization. When the spray breaks, water vapor sprays out. The reason is that the outlet pipe in the barrel is welded and removed, and it can be removed by soldering. If the spray mist shape is not conical, the reason is that the spray hole is blocked, the nozzle hole is not round, and the debris in the spray head can be removed and the spray head piece can be replaced. (3) Many leaks. The leakage of the spray bar is due to the welding or cracking at the weld joints, which should be repaired or replaced. Water leakage at each joint can be achieved by tightening the thread or replacing the gasket oil. If the switch leaks, the switch cap is loose; if the seal ring is damaged and the switch core sticks, it can be tightened, replaced, cleaned, and refueled. Mist Sprayer: (1) Difficult to start. The floater room is not properly stored due to the machinery being left unused for a long time and should be cleaned before use to ensure smooth oil passage. (2) Stop after starting. The reason is that most of the platinum contacts of the ignition system are loose, stained, or ablated. Zero large sandpaper or even a concise knife can be used to wipe off the platinum surface stains and adjust the gap between the platinum points. (3) Insufficient cylinder pressure. Due to heavy wear, new piston rings, pistons, or cylinders can be replaced. China Agricultural Network Editor